Industrial ultrasonic cleaning
Qualify cleaning on actual parts, not tank activity.
Define the cleaning problem
Industrial cleaning has to remove unwanted material while preserving the surfaces and functions that the part needs. Describe particles, oil films and polishing residues separately, and identify where the inspection will take place. Activity at the liquid surface is not a cleanliness measurement. Start with the incoming condition, the required outgoing condition and the features that must remain undamaged. Use the same acceptance language across trial batches so that a change in contamination is not mistaken for a change in equipment performance.
Choose a component family for evaluation
A tank-cleaning project can begin with cleaning transducers and a compatible generator arrangement. The linked multi-frequency models are catalogue discussion candidates, not recommendations for every tank. Decide whether different modes are useful by reviewing the process stages and the part’s tolerance for treatment. For a replacement, include the existing drawing and generator information rather than comparing labels alone. Qualification concerns the installed system. A loose component that passes an electrical check does not establish cleaning performance in the production tank.
Set parameters from the complete installation
Send the tank drawing, liquid depth, chemistry, basket construction and loading pattern to the technical team. Frequency, power, impedance and dimensions remain subject to the approved specification. If an area- or volume-based power indicator is used, document its measurement basis before comparing it with another installation. Tank-bottom area alone is not a component-count rule. Surface preparation, bonding or fastening also requires written assembly instructions. Retain the generator settings, loading drawing and inspection results together so that later adjustments can be assessed against a usable baseline.
Recognize common failure patterns
First, liquid preparation may have changed: fresh solution, temperature or degassing status can differ from the accepted trial. Second, fixtures or stacked parts may obstruct important surfaces even when an empty tank appears satisfactory. Third, a replacement component, cable or mounting method may no longer match the qualified drive and mechanical arrangement. Record what changed before changing more settings. Have the process owner and equipment team examine their respective evidence, and avoid adjusting several variables at once. An audible difference alone is not a diagnosis.
Build a repeatable acceptance trial
Use the power-selection FAQ below to prepare a loaded-tank trial with representative contaminated parts. Compare cleanliness and surface condition at the agreed critical locations inside the approved operating envelope. Keep the sample photographs and equipment observations with the recipe. If the result is inadequate, review liquid preparation, obstruction, drive compatibility and tank condition before increasing power. Release the final combination only after sample validation and written confirmation. This guide supplies a review process rather than a universal power setting, component life claim or delivery promise. Identify who owns the acceptance decision and who must approve any later recipe change.
Shantou Sunnytec Electronics Co., Ltd.EN