How much ultrasonic power does my tank need?
Tank area alone cannot determine the required power. Define the power measurement, radiating surfaces, liquid depth and loading, then validate the assembled system. Numerical sizing remains subject to the approved specification.
Three checks
Agree what the power figure measures
Ask whether the proposed figure represents electrical input, rated generator output or an acoustic quantity established by a defined measurement. Those quantities are not interchangeable. If the comparison uses area, state whether that area means the tank bottom, the active radiating surface or another agreed reference. Put the definitions in the quotation request and test record before comparing suppliers. A power figure without a measurement basis cannot reliably determine the number of components or establish acceptance. The engineer also needs the generator arrangement and the conditions under which its stated output is available.
Use a fill-in calculation instead of an invented example
An area-based worksheet can divide an approved reference power by its approved reference area to express a comparison using the same definitions. That does not make the result a universal design rule for a new tank. Leave the reference power and area blank until the technical team supplies them, then record liquid depth, loading, radiating surfaces and the applicable test conditions alongside the calculation. No numerical example is supplied here because approved inputs are not available. Do not fill the blanks with a familiar industry value or use this worksheet to bypass an equipment-level sizing review.
Look for local overdrive as well as inadequate cleaning
Increasing generator settings can change local exposure without correcting an uneven field. Excessive local action can create a risk of surface or tank damage, while a higher display reading does not prove more useful cleaning energy at the part. Document liquid level, transducer distribution, fixture obstruction and thermal conditions. Inspect the critical surfaces and the tank as part of an approved trial. The acceptance question is whether the process meets its cleaning requirement inside the permitted equipment envelope. It is not how much power can be added before something visibly fails.
Where this does not apply
An area-based reference is useful only when the definitions and comparison conditions are known. It cannot be scaled from a shallow trial bath to a deeper production tank without review, or applied while ignoring side-mounted or immersible radiators. Changes to liquid, fixtures and workpiece loading can invalidate the comparison. Without an approved operating envelope, this page is not an instruction to energize or tune a system. The tank and generator suppliers must participate in the sizing decision.
How to verify
Supply the internal tank drawing, permitted liquid-level conditions, loading arrangement and target inspection method. Ask the technical team to complete the power worksheet and state its assumptions. During the approved prototype trial, compare cleaning results at the agreed locations and preserve generator observations and tank inspection records. If one location performs poorly, investigate the field arrangement and obstruction before treating higher total power as the only solution. Freeze the accepted configuration and retain the completed worksheet with the approved specification so that later changes can be reviewed against the same basis.
Shantou Sunnytec Electronics Co., Ltd.EN