Cleaning performance dropped — how do I troubleshoot?
Check liquid temperature, level, degassing, generator, transducer and tank in that order. Record changes before replacing parts or increasing power, and use the approved process as the comparison baseline.
Three checks
Start with liquid preparation and loading
Compare liquid temperature, level and degassing status with the accepted process, in that order. Also record recent solution replacement, contamination build-up and changes to workpiece placement. Numerical temperature, timing and level requirements must come from the approved equipment procedure and applicable specification, not this troubleshooting page. If the bath conditions are unknown, replacing a transducer cannot establish the original cause. Restore a documented, comparable process condition before judging whether the equipment behaves differently. Keep representative rejected parts so that the investigation uses the actual defect rather than a remembered description.
Review the generator before inspecting the component
Check whether generator settings, alarm history or connections have changed. Qualified personnel can then inspect the transducer under the specified isolation and discharge procedure. Combine visual observations with impedance, capacitance and any required insulation checks rather than deciding condition from sound alone. Do not bypass protection, increase the drive or tune the system without an approved plan. Associate each result with the instrument and conditions used. If a known change explains the symptom, confirm that explanation through a controlled check instead of changing additional parts at the same time.
Complete the review at tank and process level
Examine the tank, mounting areas, basket arrangement and potential obstruction, then confirm that rinsing, drying and inspection still match the accepted workflow. Local residue may reflect layout rather than insufficient total power. Define success as representative parts passing the same inspection method without newly introduced surface damage. Restored activity in the tank is not, by itself, a production-release criterion. A clean result after several simultaneous adjustments does not identify the cause either. Document which controlled change restored the result and which operating conditions must be preserved to reproduce it.
Where this does not apply
This sequence concerns a routine investigation of degraded cleaning. It does not justify continued operation with cracks, leaks, insulation concerns or serious alarms; follow the equipment’s required response first. A change in workpiece material, contamination or acceptance standard may require a new process-development exercise rather than fault repair. Failure to meet a new requirement does not prove that the previous hardware has deteriorated. Involve the process owner when the task itself has changed, and keep that decision separate from the maintenance diagnosis.
How to verify
Build a timeline of changes since the last accepted production run and work through the sequence with a named owner for each check. Change one condition at a time within the approved envelope and reinspect representative workpieces. Close the investigation with the identified cause, corrective action, verification results and conditions under which production may resume. If the evidence remains inconclusive, submit the record to the technical team rather than maintaining output through an undocumented increase in power. Retain the failed and successful inspection records together so that future troubleshooting starts with evidence. Update the work instruction only after the corrective action is approved. Operators need the accepted recipe and response to recurrence, not an informal memory of the adjustments that happened to improve the most recent trial.
Shantou Sunnytec Electronics Co., Ltd.EN