FAQ · Troubleshooting & inspection

Should I replace the generator or transducer after an overload alarm?

Identify the alarm condition using the equipment procedure before replacing either component.

Three checks

  1. Save the exact alarm code, cycle stage and operating mode.

  2. Have qualified personnel inspect connections, the load and insulation using the approved procedure.

  3. Check whether a transducer, cable or mounting component was recently replaced.

Where this answer stops applying

Alarm definitions differ between generators. An explanation from another machine may not apply to yours.

How to verify

Follow the specific generator manual for fault isolation and compare the resulting measurements with the accepted baseline. Avoid repeated restarts without understanding why protection is operating.

Related questions

Basis & references

Editorial procurement checklist; confirm order-specific requirements with engineering.

Updated: 2026-11-21 · Sunnytec website editorial content; model-specific values require approved documentation.

Product center · Related application · All 60 questions · Ask a question / report a correction